Jackery Solar Generator 1000 is a solar solution that combines Jackery Explorer 1000 Portable Power Station with SolarSaga 100W solar panels. It converts sun energy captured by SolarSaga 100W solar panels into electrical power and then stores it in the Explorer 1000 Portable Power Station for later use. This solar generator is a reliable and clean power source for campers, RVs, or as an emergency backup if your power goes out.
Power Outdoors and Great for Family Use
Jackery Solar Generator 1000 is one of the best investments for your outdoor party. It's big enough to run approximately 85% of your essential outdoor appliances and electronics including blender, pellet smoker, ice shaver, radio, and projector. With multiple output ports, you can power up to 8 appliances at the same time.
Blender
(300W)
Space Heater
(350W)
Ice Shaver
(700W)
Coffee Maker
(550W)
Toaster
(650W)
Microwave
(700W)
Kettle
(850W)
3 Ways to Recharging
3 Ways to Recharging
Explorer 1000 + 2x SolarSaga 100W
Explorer 1000 + 1x SolarSaga 100
AC Adapter:
12V Car Adapter:
Safe BMS to Fully Protect You
Safe BMS to Fully Protect You
Compact but Powerful
Lightweight and Portable Solar Generator
SolarSaga 100w solar panel: Foldable design and weighs only 9.1 lbs. Convenient to carry it wherever you go. Adjust the angle with the built-in kickstand.
Explorer 1000 Portable Power Station: Weighs only 22 lbs, and it is carry-friendly with an easy-carry handle. It also fits well in small spaces to transport during camping trips, RV, and over-landing adventures.
Set up Solar Power System in 1 Minute
Connect the solar panels to the power station in just 1 minute. Far more straightforward and more convenient than traditional generators. It is also equipped with pass-through charging, allowing you to power appliances whilst solar charging. The information on the screen is easy to ready and is fully intuitive.
Green and Quiet Solar Power
0
Hrs
Recharging Time
0
Wh
Sustainable Energy Saving
PREPARING YOUR SOLAR GENERATOR
The Explorer 1000 can be quickly fully recharged within 8 hours by connecting two SolarSaga 100W solar panels together with an adapter cable (package included).
Solar recharging steps:
1. Find the DC interface on the back of SolarSaga 100W;
2. Connect the DC interfaces of 2*SolarSaga 100W with the Y Parallel Cable;
3. Connect the Y Parallel Cable with the Anderson input of Explorer 1000
Note:
1. Solar panel types and quantity depends on your purchase.
1.Solar Recharging time varies from different location, temperature, weather etc. The actual time may be different.
2. During solar recharging, keep your portable power station away from heat and direct sunlight in order to extend its life span.
3. Store in a dry and cool place, avoid contact with corrosive substances, and keep away from fire and heat sources. Avoid storing with sharp objects at the same time.
1. Your purchase order (including purchases on Solar Generator Bundles) will be shipped separately if the order contains more than one item. This shipping rule is additionally applicable for Amazon orders.
2. You can only find one tracking number in your order even if the order contains more than one package. We are pleased to email you with all tracking numbers when requested.
3. Please feel free to contact us through this email address: hello@Jackery.com or via Amazon.
The maximum input wattage of Explorer 1000 is 200w(12~30V,7.5~8.33A ). As for recharging time, it depends on which panel you are using and weather conditions, for example, the Explorer 1000 can be quickly recharged within 8 hours by connecting two SolarSaga 100W solar panels together with an adapter cable. If connecting only one single panel, the approximate recharging time is 17 hours. Recharging time may varies from different location, temperature, weather etc, the actual time may be different.
Please note that the AC output ports can only charge/power devices that operate at less than 1000-Watts, besides, the whole wattage should be under 1000 watts as well . Once exceeding, the Explorer 1000 will shut off automatically. Please refer to your device specification before purchase
Working time = 1002Wh* 0.85 / operating wattage of your device
For reference, assuming power consumption of your device is 60W (might be a box fan), working time will be 1002Wh*0.85/60w=14.2hrs (rough calculated).
Please note: actual power consumption varies from different usages, please consult Jackery for better purchase decision.
The Explorer 1000 is not waterproof. Please do not store them in humid environment for longtime
Yes, you can use the Explorer 1000 to charge devices, while it's being re-charged at the same time.
The Saga 100W is not waterproof. To maximize the lifespan of the module,Please don’t make it get wet.
As you know , the solar panels are affected by many factors, such as the intensity of the light and the angle of the panel put on the ground. 100W is tested in an ideal laboratory. However, the intensity of the light constantly changes. In addition, the angle of the light illuminating the solar panel also changes with the rotation of the sun. Please try test your solar panel under the full sunlight to see, and make sure there is no shadow cast on the panel.
We mentioned this point in the manual. Please use a soft cloth to remove the dust and dirt on the surface. Use a damp cloth to wipe the surface of the solar module to remove any remaining dust or dirt. Any guano or other adhesive should be removed as soon as possible from the solar surface to avoid a reduction in performance.
Yes, the 100W solar panel has 1* USB-C(5V,3A) output port and 1* USB-A(5V, 2.4A) output port
More
